Microwave Guide
Microwave Sparking or Arcing: Why It Happens and What to Do
Sparks inside a microwave are alarming, and they should be taken seriously. Sometimes it's a fork or a piece of foil, and the fix is simple. Other times it's burnt-on food on an internal cover or damage to the interior, and continuing to use it can make things worse.
Here's how to tell the difference.
What to do the moment it sparks
- Press Stop or Cancel. Don't open the door while it's sparking.
- Once it has stopped, unplug the microwave.
- Remove the cause if it's obvious, such as metal, foil or a container with metal trim.
- If nothing obvious is inside and it sparked with just food or an empty cavity, don't keep trying it.
Metal and the wrong containers
Metal is the usual culprit: forks, foil, twist ties, dishes with metallic trim and some takeout containers with metal handles. A single small spark from one of these can be harmless once you remove it. Check that nothing metal was inside and run a short test with a cup of water.
A dirty or burnt waveguide cover
Many microwaves have a small cover, often a thin mica sheet, on the inside wall or ceiling that protects the part feeding microwave energy into the cavity. Food splatter and grease can bake onto it. Over time that residue can carbonize and cause arcing. If the cover looks scorched, greasy or has burn marks, this is a likely cause. A cover that's only dirty can be wiped gently. A burnt, cracked or holed cover should be replaced, which is usually an inexpensive part but should be done with the microwave unplugged.
Worn paint and damaged interior
If the interior paint has chipped or worn away, the bare metal underneath can arc, especially once food splatter lands on it. Rust, bubbled paint or chips near where the sparks occur are warning signs. Minor marks aren't always a replacement job, but active arcing from bare metal usually is.
When arcing means a deeper fault
Sparking with an empty cavity, or sparking in the same spot every time after you've cleaned and removed metal, points to a cover, cavity or internal component problem. Continued arcing can damage the magnetron. If the microwave also stopped heating, see our guide on a microwave not heating for what that means.
Stay out of the back panel
The microwave's high-voltage capacitor can hold a dangerous charge even when unplugged. Cleaning the cavity and wiping a cover is fine. Taking the outer case off is not a DIY job. If the fix involves anything behind the case, call a technician.
When to call a technician
Call if the sparking continues after cleaning and removing metal, you see burn marks or damaged paint, or you smell burning. We handle microwave repair across Toronto and the GTA. For an older or low-cost unit, our guide on repair or replace helps with the decision.
Rather have a pro handle it?
Our technicians repair this across Toronto and the GTA — same-day in many cases, with clear pricing and a warranty on the work.