Dishwasher Guide
Dishwasher Leaking Water: Causes and Fixes by Where the Water Appears
A leaking dishwasher is one of those faults you shouldn't wait on. Water under the machine soaks the cabinet base, the subfloor and eventually the control board. The good news is that where the water shows up tells you most of what you need to know.
Start by working out where it's coming from. Then you'll know whether it's a ten-minute fix or a job for a technician.
First, find where the water is coming from
Run an empty cycle with a dry towel under the front and watch when the leak starts: during fill, wash or drain. That timing narrows it down quickly.
- Water at the front, around the door edges: usually the door gasket, the latch or an overfilled tub.
- Water pooling directly under the middle of the machine: usually a pump or sump seal, an internal hose or the inlet valve.
- Water at the front corner or under the sink cabinet: usually the supply line, a fitting at the shutoff valve or the drain hose connection.
- Water only during the drain phase: the drain hose, its clamp or the connection at the sink or disposal.
Door gasket and latch leaks
The rubber gasket around the door wears, hardens, picks up grease and eventually stops sealing. If the leak is at the front and the gasket looks cracked, flattened or dirty, wipe it clean and check it again. A torn or stiff gasket needs replacing. A latch that doesn't pull the door tight can leak the same way, so check that the door closes firmly with no gap.
Pump seal, spray arm and sump leaks
Leaks from the middle of the base usually come from inside the machine: a worn pump or sump seal, a loose internal hose clamp or a cracked spray arm throwing water at the door. These need the lower panel off, and often the machine pulled out, so they're normally a technician job. Many dishwashers have a float switch in the base that stops the cycle when it finds water, which is why a leaking machine may stop and show a fault code.
Inlet valve and supply line leaks
The water inlet valve admits water during fill. If it cracks or the connection loosens, it can drip even when the machine is idle. A leak at the supply line or the shutoff valve under the sink is on the plumbing side, not the dishwasher. If the drip is at the shutoff valve or the supply line fitting, a plumber may be the right call (see do you need a plumber for dishwasher repair).
Drain hose and air gap problems
A drain hose with a loose clamp, a split or a kink can leak under the sink during the drain phase. A partly blocked drain path can also push water back where it shouldn't go. If the machine is also leaving standing water in the tub, see our guides on a GE dishwasher that won't drain or a Bosch dishwasher that won't drain.
What to do right away
- Switch the dishwasher off at the breaker and close the supply valve under the sink.
- Mop up standing water and lay towels down so you can see where new water appears.
- Don't keep running cycles to see if it stops. Each one puts more water against the wiring and the cabinet.
- If a code is showing and the machine has stopped, it may have detected the leak itself. The code guides for GE E4 and Bosch E15 explain what those leak codes mean.
When to call a technician
Call if the water comes from inside the machine, from the base or from a door that still leaks after cleaning the gasket. We handle dishwasher repair across Toronto and the GTA, and we'll find the source before quoting. If the machine is old and the repair is large, our guide on repair or replace helps you decide, and appliance repair cost explains what affects the price.
Rather have a pro handle it?
Our technicians repair this across Toronto and the GTA — same-day in many cases, with clear pricing and a warranty on the work.